Week7 Activity: Model1&2, folding Fusion360 2.5D model, Fusion360 3D Intial Model

Week7 Activity: Model1&2, Folding Fusion360 2.5D model, Fusion360 3D Initial Model

Activity 1: Handmade model progress Model1

Plan:

Model1

This model is developed from the draft paper model from week5. As the draft paper model was very unstable and it is hard to stand straight, I decided to change to a smaller scale and a thicker material.

• material used: paperboard
• scale1:20
• folding technique used for curtain and roof
• dimension seen above in plan

This model is made of pink and blue paperboard. The material was chosen as it is easier to cut/fold comparing to paper, but the texture is same as paper.

Progress

folded paper for roof

Photographs

shadow changes due to different direction of light source

three strips on the side of the wall were cut out to provide light source

front view

top view

Handmade model progress Model2

• material used: recycled shoe box cardboard, tracing paper, recycled toilet paper rolls cardboard
• scale1:20
• dimension can be seen in plan above

cardboard model scale1:20
Tracing paper was used as curtain material to create a different texture of materials used in the model. Recycled shoe box was used as the cardboard material.

Progress

original model:

I change one side of the wall from a piece of cardboard to a wall of stacked toilet paper roll. Each recycled toilet paper roll was cut in 3 sections horizontally and in half vertically.

Photographs

Activity 2: model Fusion360 2.5d

modelling the 2.5d model using the dimension below:

Idea of modelling:

folding process:

Folding Model of fushion360 2.5d model:

the left-hand side rectangular box represents the space of hallway on the upper level; the middle box represents the staircase space; the right-hand side box represents the space of entrance walk way on the lower level.

Activity 3: Fushion360 Initial Model:

Three letters chosen are O, Z and L: